how to make a one for all passkey

how to make a one for all passkey

The biggest fault of this is you’ve reduced the grip dramatically, the smaller the nut the less grip, in the last example it looks like the nut is only properly gripped in two places so if it was tight there is a big risk of it slipping and chewing the nut points off. I’d make […]

The biggest fault of this is you’ve reduced the grip dramatically, the smaller the nut the less grip, in the last example it looks like the nut is only properly gripped in two places so if it was tight there is a big risk of it slipping and chewing the nut points off.

I’d make it about half the size, bigger v groove and make the screws flash to be more comfortable.eally very smart work.

I noticed that you changed the iron stick and make another taller one to make it easier for use because the first stick that you made was short  also to avoid this tool not to suitability for use make another one horizontal and the other side of the tool is vertical.Awesome fabrication skills.

I think this would work great for most nuts and bolts, but might chew up the heads of really stuck ones, because it has less contact surface area.

But the convenience of fitting such a range of sizes would be well worth it. Really enjoyed watching you build it.

The modified wrench has a good intention, but it can only be used for gong nuts that are not too tight. If the gong nut is tight, it will slip.You have a new subscriber!

This tool is a great idea and I am going to make it myself, so thank you ! I also really liked the background music you have used.

Sosyal Medyada Paylaşın:

BİRDE BUNLARA BAKIN

Düşüncelerinizi bizimle paylaşırmısınız ?

  • ÇOK OKUNAN
  • YENİ
  • YORUM